Introduction

Designed in partnership with the main European boat builders, the CRISTEC shore-power units combine in a single cabinet the AC circuit protection and a battery charger.The complete system meets the European on-going rules.Compact and lightweight, it provides practical entry for the cabling that reduces mounting time.The AC circuit protection is insured by a 16A/30mA residual current device (RCD/GFCI Ground fault circuit interrupter) and 2, 3 or 4 off 10A DPN miniature circuit breakers (MCB) depending on models. The battery charger function is made by an HF switch mode standard CPS2 PCB that delivers an IUoU curve (CPS PCB for 12V/10A model).

Models

12V/16A

12V/10A

12V/25A

12V/40A

Data Sheet

 

General Characteristics

Ø  Input voltage : 230VAC +/-15%

Ø  Input frequency : from 47 to 63 Hz

Ø  Display : Green LED for AC presence on the front cover

       + 2 LEDs for the charger state (1)

Ø  Input and output cabling on pass wire

Ø  External fixings

Ø  Operating temperature : from -10°C to +45°C

Ø  Protection factor : IP21

Ø  Matt black RAL 9011 and grey RAL 7035, salt atmosphereresistant

Ø  CE standards : NF EN 61000-6-1, NF EN 61000-6-2,EN60950 & ISO 13297

Ø  French manufacturing

     (1)  : Except 12V/10A model

Charger Characteristics

Ø  Input voltage: from 90 to 265VAC +/-15%

Ø  Output voltage: 12VDC +/-1%

Ø  Three automatic charge cycles: boost, absorption, floating

Ø  Timed boost by internal switch

Ø  Charge distributor incorporated into each battery output

Ø  3 outputs - Specific output matched to the engine battery charging (1)

Ø  Selection of the level of charge according to the type of battery by internal switches

Ø  Internal potentiometer allows output voltage to be adjusted

Ø  Protection against short-circuits and polarity reversal (fuses on input and output)

Ø  Low noise, thermostatically controlled electric fan on 25 and 40Amodels

Ø  Available options

(1): battery monitor digital display, temperatureprobe, remote LEDs, remote ON/OFF boost

  (1): Except 12V/10A model